HEOSafe Van additional locks for rear and sliding doors

• The lock can only be used with a key.
• The lock is opened with the key and then turned 180°.
• The key can only be removed in the open or closed position.
• Always carry the key with you.

INSTALLATION INSTRUCTIONS

• Open the lock with the key and turn it 90°. This position is the installation position. The key cannot be removed in this position.
• Mark the 4 holes with a pencil. The best way to do this is to hold the lock and plate in the correct position.

For a sliding door, the lock is attached to the side wall next to the sliding door (preferably about 10 cm above the guide rail). Before continuing, check whether the sliding door passes over the lock properly.
Install a lock on a hinged door from the inside of the door on the side to be locked.

• Drill the holes with a 3.20 mm drill bit.
• Grease the holes, attach the foam rubber seal over the holes.
• Attach the lock with the supplied self-drilling screws using a 4 mm Allen key.